Set Jumpers:
Set Jumpers:
Set Jumpers:
Set Jumpers:
Set Jumpers:
Jumpers are used to select the operation modes for your system. Each jumper on the
board has several metal pins with each pin representing a different function. A 1 is
written besides pin 1 on jumpers with several pins. To set a jumper, a plastic cap con-
taining metal contactor is placed over the jumper pins according to the required configu-
ration. A jumper is said to be shorted when the plastic cap has been placed on two pins
of it.The types of jumpers used in this manual are shown below:
Open
Short
Note:
Users are not encouraged to change the jumper settings not listed in this manual. Chang-
ing the jumper settings improperly may adversely affect system performance.
Jumper Cap
3-pin Jumper
Jumper Block
1
2
3
1
2
3
Hardware Installation
2-2
4-pin Jumper
