
General
In case of faults phone the service department.
See the guarantee certificate or consult the
internet site
www.hps.nl
.
If you notice a crack on the cooking
surface (no matter how little), switch
off the appliance immediately. Remove
the plug from the socket or set the switch of
the power supply cable (in the case of a fixed
connection) to zero or turn off the fuse switch(es)
in the meter cupboard.
Phone the service department.
This appliance should only be connected up by a
registered electrical installer!
The electrical connection must comply with
national and local regulations.
Damage caused by incorrect connection, incorrect
use or incorrect building in is not covered by the
guarantee.
88
89
fault
S
maintenance
Table
If the appliance does not work properly, this does not always mean that it is defective. Try to deal with
the problem yourself first by checking the points mentioned below:
Fault
Probable cause
Solution
After the appliance has been electrified, text appears
in the displays.
Normal operation.
NOTHING: see chapter “building in“ in the
installation part of this manual.
After the appliance has been switched on, the fuse in
the meter cupboard blows.
Appliance incorrectly connected.
Check the electrical installation.
The fan keeps on running after the appliance has
been switched off.
The electronic circuits inside the hob are being
cooled.
This is normal.
The hob does not work and the lights are not on.
The appliance has been connected incorrectly
or the mains voltage is not right.
Check the electrical installation (main fuse(s)
or the connection).
After the zone has been switched on, the displays
shows the symbol
.
The pan is not suitable for induction cooking or
the diameter is less than
12 cm.
See chapter “Pans”.
While cooking, you hear a rattling noise in the base
of the pan.
The noise is due to the high power of the
cooking zone having an effect on the base of
the pan.
This is normal for some pans on higher
settings. It is harmless for the induction hob.
When you use the hob the first time, you notice that
it smells ‘new’.
This is caused by the appliance’s finish
heating up. It is perfectly normal.
The odour will disappear of its own accord as
a result of ventilation.
Failure code
A knob was operated too long or there is a
break in the cable.
Release the knob. Phone the service
organisation if the fault persists.
Failure code E4, E5, E6 of E9
Defect of generator.
Contact the service department.
Failure code E2
Appliance over heated.
The appliance has been switched off because
of over heating. Let the appliance cool down
and start again on a lower setting.
Failure code E3
The pan is not suitable for induction cooking.
See chapter “Pans”.
Failure code
The childproof lock is switched on.
See “Childproof lock”, page 83.
Содержание A361KZT
Страница 50: ...99 98...