Etic Telecom RAS Series, Руководство по установке

Страница: 40 / 74

SETUP
Page 40
DOC_DEV_Router setup guide_A
Router Nr2 static routes :
Active Route name Destination Netmask Gateway
Yes Network 6 192.168.6.0 255.255.255.0 192.168.5.1
Yes Network 1 192.168.1.0 255.255.255.0 192.168.2.1
Yes Network
Remote WAN
192.168.4.0 255.255.255.0 192.168.5.128
Remark :
It is not necessary to enter in the router R2 the static route to the WAN network nor to the remote LAN
network, that routes have been automatically created by the router respectively when the WAN IP address
has been entered and when the VPN has been configured.
The same type of static routes must be entered in the other routers.
To set a static route,
• Select the “ Configuration ” menu, the “ network ” menu the “ Routing ” menu and then “ Static routes ”.
•
click the “Add a route” button.
“Destination IP address” & “netmask” parameters :
Enter the destination network IP address and netmask.
“Gateway IP address” parameters :
Enter the Ip address of the gateway through which the IP packets intended for that network must pass.
8.3 RIP protocol
RIP ( Routing Information Protocol ) is a routing protocol which enables each router belonging to a network to
acquire the routes to any subnet.
The principle is as follows :
Routing table
Each router holds a routing table.
Each entry of the table consists in the destination subnet address and the adjacent router address leading to
that subnet.
Routing table broadcasting :
Each router broadcasts its table .
Routing table update :
Each router updates its own table using the tables received from the other ones.
To enable RIP,
•
select the Setup>Network>Routing>RIP menu,
•
Select the ‘
Enable RIP on
LAN interface” and the “Enable RIP on WAN interface” options.