Etic Telecom RAS Series, Руководство по установке

Страница: 22 / 74

SETUP
Page 22
DOC_DEV_Router setup guide_A
4 Wi-Fi / WAN interface setup
This section applies to the below routers:
IPL-EW, IPL-AW, IPL-CW, RAS-EW, RAS-ECW
Remark :
The Wi-Fi scanner makes possible to detect the Wi-Fi networks around the Router.
To use the Wi-Fi scanner, select the Diagnostic > Tools > Wi-Fi scanner menu.
To set-up the Wi-Fi interface as a client to reach the Internet,
•
Select Set-up > WAN interfaces > Wi-Fi
•
Select the « Enable » checkbox
Wi-Fi modem set-up
« Network name (SSID) » parameter :
Enter the
name assigned to the Wi-Fi network to which the Router has to connect.
Attention : The SSID is case sensitive.
« Authentification » parameter :
Select WPA or WEP or None according to the access point set-up.
« Key » parameter :
Enter the WPA or WEP key according to the access point set-up.
Wi-Fi WAN IP set-up
« WiFi WAN priority» parameter :
Enter a medium value.
« Obtain an IP address automatically » checkbox:
Leave that checkbox selected if the IP address on the WAN interface is assigned by a DHCP server.
Otherwise unselect that checkbox and enter the IP address, the netmask and the default gateway address.
« Obtain the DNS server IP address automatically » checkbox:
Leave that checkbox selected if the DNS servers IP addresses are assigned by a DHCP server.
Otherwise unselect that checkbox and enter the IP addresses of the DNS servers.
« NAT» checkbox :
If that option is selected, the source IP address of any IP frame coming from a device connected to the LAN
interface and routed to the WAN interface, is replaced by the Router WAN IP address.
Remark: Select that checkbox if a device of the LAN interface needs to set a connection with a device
conne
cted to the Internet (FTP server …)