14
MOUNTING REMOTE CONTROLS
1) Safety precautions on Main remote controller installation.
• Connect remote controller cable after heater is unplugged.
• Never install Main remote controller above a combustion
appliance like hot plate or a kitchen range.
• The heat will cause electrical component problems, or
deform the exterior.
• Install Main remote controller out of the reach of
steam, water drop, spray of water from tea kettle,
or electrical pot.
• Do not put Main remote controller in direct sunshine.
• It is convenient to install it where it will be used most
frequently.
• Do not install Main remote controller at the place
where any commercial chemicals like ammonia, sulfur,
chlorine, ethylenic compound and acids etc are used.
• The remote controller cables carry low voltage, 12VDC
digital.
In case of installing of the fitting bracket for remote controller.
Align the slots of Main remote controller's back to 4 hooks on the fitting bracket.
Then slide them on from the top.
In case you are not using the fitting bracket of
the remote controller.
Detach right-and-left covers of the remote
controller and fix them to the wall directly with
wood screws. Then attach the covers again.
Do Not
Chemicals
Remote controller
fitting bracket
Remote controller
2) Installation of Main remote controller.
• Detach the fitting bracket from Main remote controller by
sliding it down.
• Attach the fitting plate to wall.
• Install conduit inside of wall in advance and secure the
wiring box.
• Pass remote controller cables through conduit.
Then pass the cables through the hole of the fitting bracket
and pull them out.
• Attach the fitting bracket with screws adjusting the screw
hole to the wiring box.
• Connect the remote controller cables to the terminal for the
remote controller of PCB.
Cover
Cover
Wood screw
Screw
Remote controller
fitting bracket
Hole for wiring
Hook
Remote controller
cables
Slot
Terminal