11
REMOTE CONTROLS
Refer to Technical Sheets
4.0 The ETERNITY G26 Pure 6 comes complete, with one, two or three remote control
panels, as optional extras.
4.1 These controls are to be fitted in the following locations:
*
MAIN CONTROLS - kitchen or laundry
*
SHOWER CONTROLS - main bathroom
IMPORTANT
DO NOT locate the remote controls where they may come into contact with water.
DO NOT position the remote controls in the vicinity of chemicals.
DO NOT position the remote controls over a cooker, grill oven or toaster.
DO NOT position the remote controls where materials may spill onto them.
4.2 MAIN REMOTE CONTROLS CMR-2251
The main remote controls is fitted using the mounting holes in the rear of the casing.
Wiring is from the rear using the wiring hole provided in the casing.
4.3 SHOWER REMOTE CONTROLS YST-2251 & ENSUITE REMOTE CONTROL YST-2251S
These controls must be wired from the rear, leave sufficient wire for disconnection and
removal.
4.4 CONNECTION OF WIRING TO THE ETERNITY
Remove the front cover from the unit.
Install the wiring to the ETERNITY G26 Pure 6 by concealing the wiring in the wall cavity.
Install the wiring into the cabinet through the wiring access adjacent to the power cable,
see the Technical Sheet.
4.5 Using the cable clamps provided on the plate adjacent to the terminal block attach the
wiring to the plate. Then attach the wires to the terminals for the remote controls. See
wiring diagram previous page. Replace the front cover and connect the power plug.
4.6 COMMISSIONING AND TESTING
After completing the installation of the unit, turn the water, power and gas supplies on to
the unit.
CONTROLS OPERATION
Turn the main remote controls ON by pressing the ON/OFF switch on the controls to the
ON position.
The MAIN REMOTE CONTROLS will indicate the 42
℃
and the MAIN CONTROLS light
will be alight.
Using the UP/DOWN buttons select the hot water temperature required. Turn on the hot
water supply tap. The burner light glowing will indicate that hot water is being supplied.
Move to the shower controls (if fitted). Press the TRANSFER BUTTON and repeat the
procedure.
Move to the Ensuite controls (if fitted). Press the TRANSFER BUTTON and repeat the
procedure.
THERE ARE NO MINOR ADJUSTMENTS THAT CAN BE MADE TO THE UNIT.
MODEL CMR-2251
MODEL CMR-2251
MODEL YST-2251
MODEL YST-2251S
ONE REMOTE CONTROLS SYSTEM
TWO OR THREE REMOTE
CONTROLS SYSTEM
MAIN CONTROLS
MAIN CONTROLS
SHOWER CONTROLS
ENSUITE CONTROLS