1
INTRODUCTION
ETERNITY G26 Pure 6
INSTALLATION INSTRUCTIONS
INTRODUCTION
The ETERNITY G26 Pure 6 is an external electronic gas hot water heater.
The ETERNITY G26 Pure 6 is supplied set at a constant 60
℃
outlet temperature
depending on the model purchased.
Three optional remote controls can be provided for complete hot water temperature
selection and if this option is used an approved temperature limiting device must be
installed.
THIS HOT WATER UNIT IS NOT FOR
POOL OR SPA HEATING
GENERAL
1.0.1 The ETERNITY G26 Pure 6 must be installed in accordance with
INSTALLATION MUST BE CARRIED OUT ONLY BY
AN AUTHORISED AND APPROPRIATELY LICENSED PERSON.
(1) These instructions;
(2) Uniform Building Regulations Local authority regulations;
(3) AS / NZS 3500.4 "Plumbing and Drainage Heated Water Systems"
(4) The Gas Installations Standard AS 5601 for gas burning appliances and
equipment;
(5) Any other statutory regulation that may apply;
(6) A notice of intention to install shall be lodged with the relevant Municipal
Authority and local Gas Authority prior to installation.
1.0.2
DELIVERY INSPECTION
The ETERNITY HOT WATER unit is supplied fully assembled for installation.
The customer or installer upon delivery of the unit should immediately remove all
packing materials and inspect the unit for damage and ensure that the unit supplied
is correct for the gas supply to which it is to be connected, report any damage or
discrepancies quoting to the supplier the serial number and model number, which
can be found on the outside of the cabinet.