Menu and Configuration
25
Arch Setup Menu
Station Power
Station Power determines whether or not the built-in Echo station
power supply is turned on or off. Default is Off. Only one Echo
station power supply should be turned on per Echo system. See
for more information about station
topologies.
Remote Record
Remote Record controls whether preset record is allowed from
connected Echo control stations. Options include On or Off.
Default is Off.
Data Source Settings
• DMX Input: Determines if the DMX input port to the controller is Enabled or Disabled. The default
is Enabled.
• DMX Priority: Determines priority level at which the DMX input will be treated in the
prioritization. See
for more information about source
prioritization. The default value is 100.
• Arch Priority: Determines the playback priority to be used for preset, sequence, and zone
activations controlled by the connected Preset Stations. The last action takes precedence. See
for more information about source prioritization. The default value
is 100.
• Contact Priority: Determines the priority of the contact input source. The range can be set from
1–201 with a default of 100.
• Packet Delay: Allows the controller to manage the number of times a DMX value must be present
before acknowledging and reacting to that value. With the default setting of “0”, the panel will
react the first time it receives a valid DMX command. With the max setting of “10”, the panel will
react after receiving the same DMX command ten times.
Data Loss & Power On
• Data Loss Settings: This selection displays a sub-menu that allows configuration of the DMX Loss
Behavior, sACN Loss Behavior, and Power On Behaviors.
.
• Wait Time: Determine the wait time in minutes and seconds if the mode is set to “Wait and
Fade”. Range is from 0–59 minutes and 0–59 seconds. The default wait time is 3 minutes, 0
seconds. If the mode is set to “Hold Last Look”, the time displays as “Forever” and cannot be
modified.
• Fade Time: Determine the fade time in minutes and seconds. Range is from 0–59 minutes and
0–59 seconds. The default is 3 seconds.
Note:
DMX refreshes approximately 40 times per second.
Arch Setup
Station Power:
On
Remote Record:
On
Data Source Settings
Data Loss & Power On
Preferences
Network Settings
Contact Inputs
Timeclock
DMX Loss Behavior
Mode: Wait
and
Fade
Wait Time:
3min 0sec
Fade Time:
0min 3sec
sACN Loss Behavior
Mode: Hold
Last
Look
Wait Time:
Forever
Power On Behavior
Power On:
Last-Look
• Mode: may be set to “Wait and Fade”, or “Hold Last Look”. Loss
behavior defaults to “Hold Last Look”.
- Hold Last Look: Holds any active dimmers at whatever levels they
were receiving prior to the loss of data. The last levels are retained
until data is restored or another source takes control.
- Wait and Fade: Holds the last levels received when the data was lost
for a user-defined amount of time and then fades those input levels
to zero intensity using a user-defined fade time. The default wait
time setting is three minutes and zero seconds. The default fade time
setting is three seconds.
Содержание Power Control Processor
Страница 6: ...iv Power Control Processor Configuration Manual ...
Страница 61: ...Web UI 55 ...
Страница 62: ...56 Power Control Processor Configuration Manual ...
Страница 63: ......
