ETC EUTRAC, Планирование и руководство по установке

Страница: 5 / 50

Introduction 3
General Warnings
Read and save these instructions before installing ETC DataTrack, and refer to them when
making additions to or changes in the DataTrack configuration.
WARNING:
Mains voltage must be switched off before installation or maintenance of
track or track components.
WARNING:
Do not install any part of this track system less than 5 ft (1.5 m) above the
floor.
WARNING:
Do not install any fixture assembly closer than 6 in (15.2 cm) from any curtain
or similar combustible material.
WARNING:
Always disconnect electrical power before adding to or changing the
configuration of the track.
WARNING:
Do not attempt to energize anything other than lighting track fixtures on the
track.
WARNING:
Do not attempt to connect power tools, extension cords, appliances, or
similar devices to the track.
CAUTION:
This document describes 120V DataTrack installations and is not intended for
for the planning and installation of 230V installations. 230V installations
require different power configurations than those described here.
CAUTION:
For indoor use only. Do not use in wet or damp locations.
CAUTION:
Unauthorized modification of DataTrack or DataTrack components may void
ETC warranty.
CAUTION:
Material used for ceiling mounting must conform to building regulations.
Note:
Never mount the DataTrack system on a wall. Wall-mount installation is not
supported.
Note:
Do not slide track adapters when moving fixtures. Fixtures should be fully removed
from the track, relocated, and then properly re-attached.