Etac Prio 13420305, Руководство пользователя

Страница: 27 / 44

27
Etac / Prio / www.etac.com
16”
14 Nm
17 mm
24 mm
20”, 22”, 24”
16”
1 2a
2b
!
14. Advanced settings, adjustments
Changing the rear wheel position
1. Loosen the nut.
2. Open the kit with the washers and install at the required position
(see table in Section ”Seat height table” ).
An adaptor sleeve should be used with 16" wheels in positions A2
and B2.
3. Adjust the castors/castor fork so that the chassis
undercarriage is horizontal (see section
”Height adjustment, front” ).
4. Adjust the user brake, see section ”Brake, adjustment” .
Bear in mind the risk of tipping.
Always check the positioning of the anti-tips.
In certain rear wheel positions, there is a crushing
hazard between the arm support and rear wheel (if
the arm support is set at low height).
During installation, make sure that the hubs end up
in the same position on the right and left side.
During installation, check that the rear wheel is
securely mounted. The button in the hub should
pop out to the original position. Test by pulling the
wheel.