eta ETA007090000, Инструкция по эксплуатации

Страница: 57 / 100

EN - 57
EN
Shaft extraction
1. Turn round the dish upside-down.
2. Rotate the locking nut
26
anti-clockwise
until the shaft releases
3. Now it is possible to take out the shaft
25
from the dish. Check whether the contact
surfaces of the shaft and nut on the
dish are clean and whether the sealing
installed on the shaft is not damaged.
25
26
8
4. Reverse assembling shall be performed
in opposite order. Insert the shaft
25
up
to the bottom of the dish, turn round the
dish upside-down, put on the locking nut
26
and rotate the nut clockwise until the
arrows on the nut point to the locks on
the dish.
5. Check that the shaft is held firm in the
bottom of the dish. Now the dish is ready
to use. You may place it to the base of
the appliance with the logo directed to
you. Push it steady downward so that it
fitted.
6. Connect the appliance to the mains by
means of the supply cable
9
and switch-
on the main switch
10
situated on the left
down side next to the ventilating grille.