ESTeem 195C, Руководство пользователя, Страница: 55 / 75

APPENDIX A
SOFTWARE COMMANDS
Revised: 10 Oct 2017 APX A-7 ESTeem Models 195MHC
setcon (r1,r2,r3,da)
This command defines the destination address for the ESTeem to perform a connect when data arrives in the configured serial
device interface (sdi). This function supports a direct connect or a connect through a maximum of three repeaters.
r1 = ESTeem address (1 to 254) of repeater 1.
r2 = ESTeem address (1 to 254) of repeater 2.
r3 = ESTeem address (1 to 254) of repeater 3.
da = Destination address (1 to 255).
sread
This command will complete an instantaneous read of the values in the four 4/20mA sensors.
stopbits (1-2)
This command sets the number of stop bits for the serial device interface. This command is used with baud, parity, databits to
configure the serial port on the ESTeem. Factory default = 1.
telnet (on/off)
This software command enables and disables the telnet access to the radio for additional security. Factory default = on.
on: Enabled
off: Disabled
termt (0-5000)
The serial device interface, receive termination timer value. This value is the time after the last serial data bit is received in the
serial buffer that the modem will wait for further data. If additional data is received from the device, the ESTeem will make an
RF packet and send to the remote ESTeem. This value can be 0 to 5000 milliseconds. Factory default = 6O.
txdelay (0-500)
Number of milliseconds the ESTeem 195M/H/C will wait after receiving serial or Ethernet data packet before transmitting to
remote. Factory default = 1.
xhflow (0-1)
This command enables hardware flow control. Factory default = 0 (Disabled).
0 = Disabled.
1 = Enabled.
version
This command will display the current firmware version, boot loader version and firmware CRC.
vinaux
This command will display the DC voltage input in the auxiliary power is used.
zerotables
This software command will reset the Routes and Append commands to factory defaults (All blank).