ESTeem 195C, Руководство пользователя, Страница: 50 / 75

APPENDIX A
SOFTWARE COMMANDS
Revised: 10 Oct 2017 APX A-2 ESTeem Models 195MHC
arpproxy (on/off)
The arpproxy command enables the ARP Proxy for Ethernet communications. See Chapter 5 for full details on Ethernet
communication. Factory default = off
on =
Enabled.
off = Disabled.
baud (2400-115000)
This command sets the baud rate for the serial device interface (SDI). The other commands are the data bits, parity and stop bits
cert
This command will display the certification for the ESTeem 195M/H/C. The FCC ID, Canadian DOC ID and serial number of the
modem will be displayed.
chspace (1-2)
This command will set the channel spacing for the ESTeem 195M/H/C.
1 = 6.25 kHz channel spacing
2 = 12.5 kHz channel spacing
Factory default = 2 (12.5 kHz channel spacing)
connect (r1,r2,r3,da)
This command performs the connect to a destination ESTeem. This function supports a direct connect or a connect through a
maximum of three repeater nodes.
r1 = ESTeem address (1 to 254) of repeater 1.
r2 = ESTeem address (1 to 254) of repeater 2.
r3 = ESTeem address (1 to 254) of repeater 3.
da =Destination address (1 to 254).
console (on/off)
This software command enables and disables the serial console access to the radio for additional security. Factory default = on.
on: Enabled
off: Disabled
crcval (on/off)
The crcval command enables the 195M/H/C to validate the value for CRC error check in serial Rockwell Automation DF1 packets.
If the CRC is found invalid, the packet will be discarded. Factory Default = off.
on =
Enabled.
off = Disabled.