ESTeem 195C, Руководство пользователя, Страница: 53 / 75

APPENDIX A
SOFTWARE COMMANDS
Revised: 10 Oct 2017 APX A-5 ESTeem Models 195MHC
parity (0-3)
This command defines the parity setting on the serial device interface. This command is used in conjunction with baud, databits,
and stopbits to set the complete serial configuration. Factory default = 0 (None).
0 = None Parity
1 = Even Parity
2 = Odd Parity
passp <Passphrase> (1-64 characters)
This software command will use the characters in the Passphrase to generate the AES encryption key. The key is generated from
1-64 characters entered after the passp command (example: passp 12345678) and is case sensitive. Typing the passp command
without any arguments will display the current Passphrase.
plcproto (0-7)
This command defines the PLC protocol emulation used on the selected serial device inteface. Factory default = 0 (None).
0 = None
1 = Rockwell Automation DF1
2 = Modbus RTU Protocol
3 = Modbus ENC_RTU Protocol (Configuration Protocol)
4 = ModbusTCP
5 = Opto22 Protocol
6 = Modbus ASCII
7 = Rockwell Automation EthernetIP (Reserved)
8 = Remote
program (1-254,1-254,1-254,1-254)
This command is used to remote program another ESTeem unit. Example prog 10 (Unit 10 is the address of the remote
unit). Remote programming can be completed through repeaters. When a connection has been made with the remote ESTeem
the RPG: prompt will appear. The RPG: prompt is the command prompt of the remote modem.
radio (on/off)
The radio transmitter enable command. The ESTeem radio transmitter will cycle on and off when enabled for tuning and
antenna testing procedures. Factory default = off.
ON:
Enabled.
OFF: Disabled.
reset
The software reset command for the ESTeem. The execution of this command resets the internal electronics in the ESTeem.
retry (0-99)
The retry command number. This is the number specifying the number of retries, retransmission of frames, that are not
acknowledged. Frames are retransmitted RETRY times before operation is aborted. Factory default = 6.