
APPENDIX A
SOFTWARE COMMANDS
Revised: 10 Oct 2017
APX A-1
ESTeem Models 195MHC
Listed below in alphabetical order are the definitions of the ESTeem software commands. All software commands are entered
lowercase. The commands are displayed below with the full software command and the shorted command underlined.
? or help
help
Displays the modem information and sub help menus.
help all
Displays all commands switches and arguments.
help change
Displays only the commands that are changed from factory default.
help control
Displays control commands switches and arguments.
help plc
Displays plc commands switches and arguments.
help radio
Displays radio commands switches and arguments.
help interface
Displays interface commands switches and arguments.
help setup
Displays setup commands switches and arguments.
help system
Displays system commands switches and arguments.
help 192compat Display commands for 192 compatibility
192compat (on/off)
This function sets the compatibility with legacy Model 192 products. The software command lowers the data rate to match the
Model 192 (9,600 bps) running in narrow band configuration.
Factory default = off
a_bctrl (1-4)
This function selects the Rockwell Automation (Allen-Bradley) DF1 controller protocol. Full emulation is enabled with the PLC
Protocol (plcproto) software command
1 = Full Duplex DF1 with CRC Error Checking
2 = Full Duplex DF1 with BCC Error Checking
3 = Half Duplex DF1 with CRC Error Checking
4 = Half Duplex DF1 with BCC Error Checking
Factory default = 1.
address (1-255)
The command defines the ESTeem source address. The default value is the last octet of the stored IP address. For example is
the IP address of the ESTeem 195M/H/C is 172.16.10.184, the address of the modem would be 184. Addresses 1 to 254 are
usable for unit addressing. Address 255 is used for GLOBAL.
appendroute (l#,r#,a1,a2,g)
The appendroute command appends routes to a connect address that are defined by the ROUTE command.
l # =
Location of route number in memory. Address locations 1 to 64.
r # =
Appended route number. Route numbers 1 to 64.
a1 = Address of first destination node. Address numbers from 1 to 254.
a2 =
Address of last destination node. . Address numbers from 1 to 254.
g
=
Group feature is enabled by inserting a 1 in this field.
Factory default = 0. APPEndru 0 disables this feature.
Note:
This command is used in conjunction with the ROUTE Command.
Содержание 195C
