ESTeem 195C, Руководство пользователя, Страница: 51 / 75

APPENDIX A
SOFTWARE COMMANDS
Revised: 10 Oct 2017 APX A-3 ESTeem Models 195MHC
crypto (on/off)
This software command will enable an over-the-air, wireless encryption at 256-bit AES. All ESTeem 195M/H/C in the same
wireless network must have the same encryption settings and keys. See software command passphrase (passp) to set the
encryption key.
on =
Enabled.
off = Disabled.
csthresh (-150 through -50)
This command is the carrier sensed threshold for the receiver in the ESTeem 195M/H/C. The values are listed in dBm and must
be entered with the negative (-) value before the command. Adjustment of this command is only necessary in very high noise
environments. Factory default = -80dBm.
databits (7-8)
This command sets data bits in the serial device interface. This command used with baud, parity and stopbits commands.
Factory default = 8.
disack (on/off)
This command when enabled instructs the modem to disable the acknowledgment request on the information packet. This is
used when the designation device will respond with its own acknowledgment. Factory default = off.
on: Enabled
off: Disabled
disconnect
The disconnect command. The execution of this command immediately initiates a disconnect request with the currently
connected node.
eth_bridge (on/off)
This command enables the Ethernet bridge on the ESTeem 195M/H/C. See Chapter 6 for full details. Factory default = off.
on: Enabled
off: Disabled
factory
The factory default command. The execution of this command causes the ESTeem to restore the command table values from
factory values that are stored permanently in memory. This will allow the user the ability to restore the ESTeem to factory
conditions during testing or set-up.
frequency (150.000-174.000) or (440.000-470.000)
This command programs the frequency of operation in the ESTeem 195M/H/C. The frequency is entered in MHz. Available
frequency ranges for each model listed below:
Model 195M = 150.000-174.000 MHz
Model 195C = 440.000-470.000 MHz