Estate Swing E-S 1000D Series, Инструкция по эксплуатации

Страница: 18 / 48

IMPORTANT: Determining Correct Setback
E-S 1000D Series Instruction Manual
2.7
Below are 2 common examples of setback mountings & common mistakes made.
These are not the only options for mounting.
There a 3 factors to keep in mind when finding the setback mounting:
1) The measurements must be correct from the center of the hinge of the gate to the center of the
hole on the mounting bracket.
2) There must be clearance for you opener to attach to your gate in the open position.
3) The brackets do not move or pivot after mounting, if you can achieve the setback and
clearance then bracket position is inconsequential.
It is best to C-Clamp brackets on and test arm movement clearance before permanently
attaching them.
To determine the position of the gate mounting bracket (above is for the post mounting bracket)
refer to step 13 in the section “Installation of operator - PTO”
A B Sum
a
4 ¾" 5 ¼" 10 110
5 ¼" 5 ¼" 10 1/2 100°
5 ½" 5 ½" 11 90°
Variations to the ideal setback can be made, so
long as the total is less than the combined
measurements for the desired opening arc and the
motor body is more than 2 inches away from the
gate in both the open and closed position. (v
variations significantly reduces the length and
weight capacity of the operator)
*Rear pivot point indicated by gray tip. It may face
up or down depending on the side of the gate.
Use one of the rows below:
10 1/4 ”
5
3/4
”
4
3/4
”
5 1/4”
OK
*Rear mounting forced incorrect setback.
NO
NO
OK
*Measurement not from center hinge.