Estate Swing E-S 1000D Series, Инструкция по эксплуатации

Страница: 16 / 48

Installation of Operator—Pull-to-Open
E-S 1000D Series Instruction Manual
2.5
8. Place the lower “L” shaped bracket so the
top of the bracket is aligned with the bottom
marking on the post. Mark then drill and attach
the bracket using 3/8” carriage bolts. [
See Fig.
6 ]
Check “L” shaped bracket for levelness before
putting in the second bolt.
9. Place the upper “L” shaped bracket and the
boomerang bracket on the lower “L” shaped
bracket.
Position the brackets in the setback
that is being used.
10. With the 3 brackets clamped together,
mark then drill the upper “L” shaped bracket in
place and attach it using 3/8” carriage bolts.
[
See Fig. 7 ]
11. Drill through the center hole of the “L”
shaped set to penetrate the boomerang
bracket.
Double check the setback on the
boomerang bracket.
12. Drill the set hole through all 3 brackets using
a 5/16” drill bit in an area behind the first hole.
Secure the hole with a 5/16” bolt and the
provided nuts and lock washers. [
See Fig. 8 ]
13. WITH THE GATE IN THE CLOSED POSITION
measure 44” from the center of the hole on the
boomerang bracket to the center of the hole
on the gate bracket - this should be the position
of the gate bracket on the closed gate. [
See
Fig. 9 ]
14. Additionally measure and mark the gate
mounting bracket so that it is vertically
centered on the horizontal bar.
15. To ensure that the gate mounting bracket is
leveled, secure one side of the bracket, check
for levelness, and secure the other side with
provided carriage bolts, nuts, and washers.
[
See Fig. 10 ]
BEFORE PERMANENTLY ATTACHING ANY BRACKETS, BE SURE TO TEST ARM
MOTION AND CLEARANCE.
Fig. 6
Fig. 7
Fig. 8
Fig. 10
Fig. 9