Estate Swing E-S 1000D Series, Инструкция по эксплуатации

Страница: 26 / 48

Easy Wiring Under Driveway
E-S 1000D Series Instruction Manual
3.4
This portion of the manual will explain how to create an easy conduit for the wires for
dual gates.
This is what you would need to get started:
- Narrow shovel.
- ¾’ water pipe no more that 5’ in length (you would
need a total number of pipes that would equal your
driveway width plus 1’).
- ¾’ electric rigid pipe couplings (one for each joint in
the water pipe).
- 1 ¾’ “Tee”.
- 1 ¾’ Plug.
- 1 ¾’ male galvanized pipe X female hose fitting
(usually in Brass).
- Large hammer.
All the above items could be found in a local
home supply store.
Dig a trench perpendicular to the driveway
approximately 6 to 8 inches deep and 6’ long
Hook up a typical garden hose assembled
to the first length of pipe as shown
Turn on water and push the pipe under the
driveway, matching the pitch of the driveway.
If you hit a rock use the hammer to force the
pipe past the rock.
Attach additional pieces of pipe to the initial
length by removing the tee and using the cou-
pling to add the additional length of pipe,
reassemble the tee and repeat the above
steps until only 6 inches of pipe is sticking out
from under the driveway. On the opposite side
of the driveway look for a wet spot or water
bubbling up, dig to find the end of the pipe.
This process is good for driveways
up to 24’ in width.