Escient Fireball E-2, Руководство пользователя

Страница: 182 / 369

E2/DVDM REMOTE CONTROL GUIDE WD007-1-2
5/27/2005
6325 Digital Way Indianapolis, IN 46278 317.616.6789 phone 317.616.6790 fax www.escient.com
Controlling Multiple FireBalls with 1 Remote
Every FireBall E2 and DVDM is preset from the factory to operate from the FB1 source button,
however, the FireBall can be configured to use any one of the four source buttons using the on
screen Setup menus. This is useful when there are multiple FireBalls installed at the same
location, so all FireBalls don’t respond to the same IR commands. Use the following steps to
change which source button (FB1, FB2, FB3, or FB4) each FireBall will listen for commands
from:
ƒ Press the Setup key on the remote to display the FireBall setup menu.
ƒ
Highlight and Select the Utilities menu item.
ƒ
Highlight and Select the IR Remote Control menu item.
ƒ Highlight and Select which source button to use to control this FireBall.
ƒ
Press the new source button on your remote to reconfigure the remote and confirm the
change by selecting the OK button on screen.
Repeat these steps for each FireBall in your system, selecting a different FB button for each.
Resetting the FB Source Buttons
The FB1, FB2, FB3, and FB4 source buttons are preprogrammed at the factory with the
correct codes to control four FireBals. If you changed these buttons to control other devices,
you will have to reset the FB Source buttons back to the original codes in order to control
FireBalls again. Use the following steps to program these buttons back to their factory states:
ƒ
Press the FB1, FB2, FB3, or FB4 source button to be re-programmed.
ƒ
Press & Hold the “Code Set” button on the remote until the LED flashes twice.