Escient Fireball E-2, Руководство пользователя

Страница: 145 / 369

FIREBALL Advanced Users Guide WD041-1-1
10/26/2004
Page 39 of 70
6325 Digital Way Indianapolis, IN 46278 317.616.6789 phone 317.616.6790 fax www.escient.com
3. Now, whenever you press VOL +, VOL –, or MUTE on the Remote, volume will be
controlled by your TV.
Programming the Source Buttons to Control a Legacy FireBall Product
The FireBall remote can also be programmed to control a single FireBall H, E-40, E-120, MP-
100 or TuneBase 200. Any of the eight source buttons can be programmed to control one of
these FireBall products.
Follow these steps to control a legacy FireBall Product:
1. Press the source button to be programmed.
2. Press & Hold the “Code Set” button on the remote until the LED flashes twice.
3. Enter “987” using the remote’s numeric keypad. The LED should flash twice again.
4. Enter “0086”. The LED will again flash twice indicating the programming was
successful.
Note: This programming feature sets one of the source buttons on the FireBall remote to
emulate the
FB button on the legacy FireBall product remote, therefore, you must set the
legacy FireBall device to use the “ FB ” source button within it’s Setup/Utilities/IR Remote menu.
Resetting the FB Source Buttons
The FB1, FB2, FB3, and FB4 source buttons are preprogrammed at the factory with the
correct codes to control four FireBall products. If you changed these buttons to control other
devices, you will have to reset the FB Source buttons back to the original codes in order to
control a FireBall again.
Following steps to program these buttons back to their factory states:
1. Press the FB1, FB2, FB3, or FB4 source button to be re-programmed.
2. Press & Hold the “Code Set” button on the remote until the LED flashes twice.
3. Enter “987” using the remote’s numeric keypad. The LED should again flash twice.
4. Enter the factory reset code which corresponds to the FB button being reset:
o
“0082” for FB1
o
“0083” for FB2
o
“0084” for FB3
o
“0085” for FB4
5. The LED will again flash twice indicating the programming was successful.
Repeat these steps for each FireBall in your system, selecting a different FB button for each.
Using the Macro key
The Macro key is used to enter a command sequence of two or more IR commands. Macros
are used to directly access any title, group, or station from the wireless keyboard, remote
control, or an external IR control system.
Direct Media Access IR Keyboard Definitions
Function Multi-Key Combinations
Direct Play Mode Macro, M, [play mode number], Enter