Escient Fireball E-2, Руководство пользователя

Страница: 151 / 369

FIREBALL Advanced Users Guide WD041-1-1
10/26/2004
Page 45 of 70
6325 Digital Way Indianapolis, IN 46278 317.616.6789 phone 317.616.6790 fax www.escient.com
5. Press the Fireball (swoop) source button.
6. Press & Hold the “Set” button on the keyboard until the LED flashes twice.
7. Slowly enter:
o
1119 for the FB1 button
o
1120 for the FB2 button
o
1121 for the FB3 button
o
1122 for the FB4 button
8. The LED will again flash twice indicating the programming was successful.
The transport buttons on the top right of the keyboard are programmed to operate the FireBall,
however, they are actually programmed onto the CBL source buttons.
The CBL button functions as the FB1 remote source button on the keyboard. This button
“punches-thru” to the swoop key so that both are enabled when either the Swoop or the CBL
button has been pressed. However, the CBL button is not available as a universal source
when it has been programmed as the FireBall transport source button.
DO NOT program the CBL source button to control any other devices. Doing so will prohibit
the use of the transport keys for controlling the FireBall.
If you accidentally reprogram the CBL source button, use the following steps to program the
CBL button back to control the FireBall transports:
ƒ
Press the CBL source button.
ƒ
Press & Hold the “Code Set” button on the remote until the LED flashes twice.
ƒ Enter the CBL reset code which corresponds to the FB source being reset:
o
“1370” for FB1
o
“1371” for FB2
o
“1372” for FB3
o
“1373” for FB4
ƒ
The LED will flash twice indicating the code was accepted.
Programming the Universal Source Buttons