P
AGE
150
F
IRE
B
ALL
DVDM-100 I
NSTALLATION
& U
SER
’
S
G
UIDE
-
M22003-01A1
A
PPENDIX
C - M
INOR
T
ROUBLESHOOTING
Minor Troubleshooting Tips
Following are some easily resolved problems you may encounter during the installation
of your FireBall DVDM-100 unit. If you are experiencing difficulties that do not appear
in the following list, please contact your dealer, check the Escient Website, or contact
Escient tech support.
No Power
FireBall DVDM-100 may be plugged into an unswitched AC power receptacle.
Power: but no video
Make sure FireBall DVDM-100 is connected to the video source (television) before you
power on FireBall DVDM-100. Make sure that the LED next to the Power button is not
blinking. The following is the Power ON/Standby sequence:
After the FireBall DVDM-100 unit is plugged in, the Standby LED located next to the
power button will flash red until the startup process is complete.
This may take a few
minutes
.
When the Standby LED is solid red, the FireBall DVDM-100 is now in a standby or
“sleep” mode.
Press the Power button (on the front panel or on the remote) once and the video output
and front panel display will turn on and the Standby LED will be solid blue. The unit is
now ON.
Содержание FireBall DVDM-100
Страница 1: ...Escient Manual No M22003 01A1 Revision 1 0 October 2003 Copyright 2003 Installation and User s Guide...
Страница 35: ...PAGE 35 FIREBALL DVDM 100 INSTALLATION USER S GUIDE M22003 01A1 CHAPTER 2 SETTING UP...
Страница 175: ...PAGE 175 FIREBALL DVDM 100 INSTALLATION USER S GUIDE M22003 01A1 X Index...