Escient FireBall DVDM-100, Инструкция по установке и эксплуатации

Страница: 162 / 185

P
AGE
162
F
IRE
B
ALL
DVDM-100 I
NSTALLATION
& U
SER
’
S
G
UIDE
- M22003-01A1
A
PPENDIX
G - R
EMOTE
C
ONTROL
If the LED did not blink twice, then repeat steps 2 through 3 and try entering the
same code again.
4. Aim the Remote at the component and press PWR once. It should turn off. If it does
not respond, repeat steps 2-3, trying each code for your brand until you find one that
works. If the device does not have a PWR key, press PLAY.
5. Repeat steps 1 through 4 for each component you want the Remote to control.
Example: Programming a TV source device
1. Turn on the TV. NOTE: Please read steps 2-4 completely before proceeding.
We recommend highlighting or writing down the code for the brand you wish to
program before moving onto step 2.
2. On the Remote, press TV. Press and hold CODE SET until the LED blinks twice,
then release CODE SET.
3. Use the Setup Codes For TV (last section in this appendix) to locate the brand name
and then enter the first four-digit code for your component. If performed correctly,
the LED will blink twice. NOTE: If the LED did not blink twice, then repeat steps 2
through 3 and try entering the same code again.
4. Aim the Remote at the TV and press PWR once. It should turn off. If it does not
respond, repeat steps 2-3, trying each code for your brand until you find one that
works. If it still does not work, try searching for the code (see Searching For Your
Code).