Escient FireBall DVDM-100, Инструкция по установке и эксплуатации

Страница: 45 / 185

P
AGE
45
F
IRE
B
ALL
DVDM-100 I
NSTALLATION
& U
SER
’
S
G
UIDE
- M22003-01A1
C
HAPTER
2 - S
ETTING
U
P
FireBall DVDM-100 Power States: On, Standby, Off
After the FireBall DVDM-100 unit is plugged in, the Standby LED located next to the
power button will flash red until the startup process is complete.
Please wait. This may
take several minutes .
When the Standby LED is solid red, the FireBall DVDM-100 is now in a standby or
“sleep” mode. There is no video output when FireBall DVDM-100 is in standby mode.
Press the Power button (on the front panel or on the remote) once and the video output is
displayed on your TV. The unit is now ON and the LED will be solid blue.
To change from the ON mode back to the standby or “sleep” mode, press the Power
button on the front panel or on the remote once. The video output will go blank and the
LED will be solid red.
If power is removed from FireBall DVDM-100 for any reason, including a power outage
or if the unit is unplugged, FireBall DVDM-100 will automatically return to the Standby
state as soon as power is restored. When FireBall DVDM-100 is turned on again, FireBall
DVDM-100 will return to the same source mode that it was in when power was lost.
To force the FireBall DVDM-100 to restart, PRESS and HOLD the Power button for
4 seconds, and release it when the standby LED starts blinking.
When the Standby
LED is off and FireBall DVDM-100 has completed its startup process, press the Power
button once to turn on the FireBall DVDM-100.
Please follow the guidelines
regarding Power ON and Power
Standby procedures.
FireBall DVDM-100 has 4 power
states:
1. ON - video output and a
solid blue light on the front
panel.
2. STARTING UP - no video
output and a blinking red
light on the front panel.
3. STANDBY - no video output
and a solid red light on the
front panel.
4. OFF - unplugged from the
wall. No video and no lights.