6
ElectraCam Instruction Manual
ASSEMBLING THE ELECTRACAM
5.
Push the propeller fi rmly onto the motor shaft
whilst supporting the end of the motor as
shown.
6.
Locate the elevator pushrod which exits from
the left side of the tail boom when viewed
from the rear.
7.
Connect the elevator Z bend (located in the
end of the elevator pushrod) into the clear
plastic control horn (attached to the elevator).
8.
New comers should use the outer hole ( to
reduce elevator sensitivity).
9.
Experts should use the inner hole.
10. Locate the rudder pushrod which exits from
the right side of the tail boom when viewed
from the rear.
11. Connect the rudder Z bend (located in the end
of the rudder pushrod) into the clear plastic
control horn (atached to the rudder).
12
New comers should use the outer hole ( to
reduce elevator sensitivity).
13. Experts should use the inner hole.
14. Slide the tail plane and fi n over the tail boom.
15. Pass the retaining bolts at the base of the fi n
through the tail plane and then through the
tail boom..
