13
ElectraCam Instruction Manual
CONTROL CHECKS
66. Elevator is controlled by the elevator stick.
Check that the direction and distance of
movement is correct.
67. Stick toward the bottom of the transmitter
the elevator should move up. When moved
toward the top of the transmitter the elevator
should move down.
68. Adjust the position of the pushrod to get
approx. 1/4” (8mm) in each direction.
Note: Use two pairs of pliers to gently change the
Z-bend to acheive neutral when the elevator
stick and trim are both centred.
69. Rudder is controlled by the rudder stick.
Check that the direction and distance of
movement is correct. Stick to the right,
rudder should move to the right and stick to
the left, rudder should move to the left.
70. If the direction is incorrect, switch the
servo-reversing switch on the front of the
transmitter.
71. Adjust the position of the pushrod to get
approx. 1/2” (13mm) movement in each
direction measured at the trailing edge.
Note: Use two pairs of pliers to gently change the
Z-bend to achieve neutral when the elevator
stick and trim are both centred.
Right Rudder
Left Rudder
Down Elevator
Up Elevator
Neutral Elevator
Neutral Rudder
