EScale ElectraCam, Руководство по сборке

Страница: 12 / 16

12 ElectraCam Instruction Manual
TRANSMITTER LAYOUT
MODE 2 TRANSMITTER LAYOUT
51. Left Stick is Throttle up and down (side to
side not used on ElectraCam).
52. Right Stick is Elevator (up and down) and
Rudder (side to side)
53. Ch.6 switch is on Left, up the top. This is used
to control the FlyCamOne ECO camera on the
ElectraCam.
(Same for Mode 1 and
Mode 2)
54 Servo reversing switches across lower front
of case.
55 Fine trim adjustments for 4 main channels.
Please see the EScale Transmitter Manual for more
detailed instructions on Transmitter functions
Throttle High
Throttle Low
Rudder
Right Rudder
Left
Elevator Down
Elevator Up
Ch. 5 switch
(Not used on
ElectraCam)
Trim Adjustments Servo reverse switches
Power
Switch
‘PDM’ Switch
MODE I TRANSMITTER LAYOUT
56. Left Stick is Elevator up and down (side to
side not used on Electracam).
57. Right Stick is Throttle up and down and
Rudder side to side
58. Retract (Ch.5) switch is on Right, up the top.
(Not used on ElectraCam). (Same for
Mode 1 and Mode 2).
59. Servo reversing switches across lower front
of case.
60. Fine trim adjustments for 4 main channels.
Please see the EScale Transmitter Manual for more
detailed instructions on Transmitter functions
Elevator Down
Elevator Up
Rudder
Right Rudder
Left
Throttle High
Throttle Low
Ch. 5 switch
(Not used on
ElectraCam)
Trim Adjustments Servo reverse switches
Power
Switch
‘PDM’ Switch
PAIRING THE ESC AND TRANSMITTER
61. PLEASE NOTE: The fi rst time that the model
is powered up the ESC must recognize the
transmitter and verify the range of throttle
motion. Follow these easy steps.
62. With the throttle stick at its lowest position,
turn on the transmitter and then plug the fl ight
battery into the ESC.
Note: Photo shows a Mode 2 transmittter
63. After a few seconds there will be a beep
tone, move the throttle stick to full throttle,
there will be another beep tone but the motor
will not start.
64. Return the stick to its lowest position for
the fi nal confi rmation tones after which the
throttle will work normally.
65. Please note that this process only needs to
be done one time. After this the throttle will
operate normally for all subsequent fl ights.
Ch. 6 switch
Used to operate
FlyCamOne ECO
camera
Ch. 6 switch
Used to operate
FlyCamOne ECO
camera