11
ElectraCam Instruction Manual
39. Your FlyCamOne ECO can also take multiple
or single photos by changing Modes.
Modes are not stored when
camera is powered off, the default
startup mode is video.
40. There are three Modes that can be selected:
- Video Mode (default)
- Serial Photo Mode
- Single Photo Mode
41. To change Modes, to Serial Photo Mode, hold
the channel 6 switch on top L/H/S of TX in the
down position for 3 sec.
42. After 3 seconds the LED will fl ash
GREEN
once every second. Release the switch.
43. To start recording photos in Serial Photo
Mode, fl ick channel 6 switch on top L/H/S of
TX. The FlyCamOne ECO will take a picture
aproximately every 4 seconds, each time the
the LED will fl ash
RED
.
44. To stop taking photos in Serial Photo Mode,
fl ick channel 6 switch on top L/H/S of TX
Hold down for 3 Seconds
45. To change Modes, to Single Photo Mode,
hold the channel 6 switch on top L/H/S of TX
in the down position for another 3 sec.
46. After 3 seconds the LED will fl ash
GREEN
once every two seconds. Release the switch.
47. To take a photo in Single Photo Mode fl ick
channel 6 switch on top L/H/S of TX, each
time you take a photo the LED will fl ash
RED
.
Hold down for 3 Seconds
48. Another option with the FlyCamOne ECO is to
rotate the image 180 degrees. This may be
usefull if you mount the camera in a different
position and the image is upside down.
49. To invert the image hold the channel 6 switch
on top L/H/S of TX in the down position for
10 seconds until the LED fl ashes
RED
twice.
Then release the switch.
50. To return the image to the original orientation,
hold the channel 6 switch on top L/H/S of TX
in the forward position for 10 seconds until
the LED fl ashes
GREEN
twice. Then release
the switch.
NOTE: Changing image orientation is preserved at
power down and must be reset manually.
Hold down for 10 Seconds
