-- 51 --
bu12d04a
DELETE
Used if you want to delete the PC card contents (
all weld data settings
).
Example
The weld data settings on the PC card are:
PC--card
1 2 3 10 12 50
Press DELETE. The PC card’s memory is
now empty.
PC--card
RECALL
Used to copy weld data settings from the PC card to the controller.
If a weld data setting already exists in the controller’s own memory.
it is written over
by that which is stored on the PC card.
Example
Press RECALL.
PC--card
Setting control
1 2 3 10 12 50
2 3 4 5 6
Setting control
1 2 3 4 5 6
10 12 50
The controller now has 3 new sets of weld data
settings (4. 5. 6) and sets 2 and 3 have been
updated with the settings that were stored on the
PC card.
Error codes
If the controller indicates a fault in the PC card. an error message appears which
briefly describes the error in question.
Check the following:
S
That the PC card is correctly installed.
S
That the PC card is not of an unknown or non--approved make.
S
That data stored on the card is compatible with the software in the controller.
S
That the PC card does not have a faulty version number and is not from an older
format.
