US EPA Environmental Response Team
User Manual For
Viper - Smart Gateway
ERT Support: 800-999-6990
Page 24
Adding the Smart Gateway MeterApp to a Survey Controller Run
The metrics in the Smart Gateway MeterApp can be added to a Survey Controller Run. This enables you to
request Deployment Manager alarms and notifications to be configured on those metrics so you can be
alerted when things such as the Smart Gateway battery level are decreasing or internal temperature is
increasing.
NOTE: It is HIGHLY RECOMMENDED to use Survey Controller’s ‘Reading Interval’ feature when adding
the Smart Gateway MeterApp to a run. Each ‘sensor’ in the MeterApp collects readings every second. By
specifying a reading interval in Survey Controller of perhaps 5 minutes for the Smart Gateway MeterApp,
you will greatly reduce the number of readings recorded. Refer to the Viper User Guide – Section 3, Part E
for additional information on configuring readings intervals in Survey Controller.
1. Modify the MeterApp to work in Survey Controller
Open the Password Generator
program located in the ‘Meters’
folder on the desktop. The program name is SEEPassword
Generator Plus.EXE.
In the Smart Gateway MeterApp, click
on
Admin
and select
Unlock
.
Enter
the code
displayed in the password
generator.
INTEROPERABILITY SETTINGS
Switch to the
InterOperability
tab
Enter a
TcpStreamTwo
IP of
127.0.0.1
Enter a
Port
of
6991
for TcpStreamTwo IP
Put a checkmark in the
Send
box for
TcpStreamTwo
Click
Save and Configure
