ERT VIPER, Руководство пользователя

Страница: 17 / 45

US EPA Environmental Response Team
User Manual For
Viper - Smart Gateway
ERT Support: 800-999-6990
Page 17

Continue through the run configuration screens.
Reading intervals can be configured and fixed
coordinates can be entered; however, the Smart
Gateway will provide coordinates if none are
entered. Click
Finish on the Run Configuration
Complete window.

Click Yes when prompted to Start Recording Data
5. Configure the MeterApp for a Serial connection to the instrument

Unlock the MeterApp

To obtain the unlocked password, use the
SEEPasswordGeneratorPlus.exe (in the ‘Meters’
folder on the desktop). Click on
Admin – Unlock in
the MeterApp and enter the code from the password
generator.

Stop the MeterApp by clicking the Run option in the
Menu and select Stop

Open the ‘Data Input Settings’ tab

Under ‘Virtual Communications Settings’ section,
enter ‘Com5 ’ for the port (use the Port
number labeled on the outside of the Smart
Gateway)

Select the appropriate baud rate for your
instrument
(refer to the Instrument section
of the Viper Guide)

Remove the checkmark from ‘Chk-Bat Sig’
(may also say Chk-Bat Volt)

Put a checkmark in ‘Use Serial Direct
Connection. NotWiFi’

Under the ‘GPS.Default TCP Optional UPD
Serial or MC Listen’ section

In the IP box, enter 192.168.4.1 (this
will obtain the GPS from the
Cradlepoint)

In the Port box enter 8024

Put a checkmark in Get GPS

Click the Save Settings button

Click the Configure button

Start the MeterApp Run by click on Run – Start

Sensors should turn green and samples should increment

Survey Controller should turn green
If the sensors in the MeterApp do not turn green and receive readings, close the MeterApp using the
‘x’ in the upper right corner and let the MeterApp open again on its own.