Ergon Crafco BAX 250, Инструкция по эксплуатации и запасным частям

Страница: 12 / 44

12
MACHINE START UP
TO START BURNER
1. Open the vent damper.
2. Open LPG tank valve and ball valve at cylinder.
3. Start engine per instruction below.
4. Turn “ON” power toggle switch at control box.
5. Set material temperature at manufacturers recommended temperature.
CAUTION:
If burner does not ignite the first time, turn temperature dial to off. Turn
temperature dial to desired setting. Burner should ignite. If burner still does
not ignite, determine cause of malfunction (see Burner Trouble Shooting Guide
pg. 22).
STARTING THE ENGINE
Choke engine, turn the ignition key to start position. Engine should start. After engine
starts, allow to warm up before using hydraulics or generator.
STARTING THE MIXER
When the sealant material reaches 275 o F, engage the mixer by moving the toggle switch to
“ON” (switch located on hydraulic panel.) If the mixer does not move, allow
material to heat longer. Jamming of mixer shaft causes hydraulic oil to overheat and
machine damage could occur. Remember, mixer does not start with melter lid open. The
mixer speed is preset for optimum performance for the factory.
HEATED HOSE, WAND, AND CONTROLLER
CAUTION:
The hose must be up to temperature before dispensing can take place.
IMPORTANT!! DO NOT twist or kink hose. Avoid sharp bends and continuous
twisting. Maintain minimum 10” bend radius. DO NOT exceed 400 degrees!!
DO NOT move or bend hose when cold. Damage may result.
The heated hose supplied with the machine is Teflon lined with a stainless steel overbraid.
It has a heating element which runs down the hose to heat the material within the hose.
The hose is insulated with silicone foam rubber and is covered with a durable rubber outer
covering. The wand has an aluminum tube to protect both the wand and the operator. The
pistol grip actuator is equipped with an electric switch which when depressed sends a
signal to actuate the pump. At the end of the wand, a high temperature elasomeric output valve
is attached. The valve is pressure actuated and opens automatically when fluid pressure is
applied. The wand is equipped with a trigger lock to prevent accidental pump actuation when
not pumping material.