Ergon Crafco BAX 250, Инструкция по эксплуатации и запасным частям

Страница: 15 / 44

15
INSTRUCTIONS FOR ORDERING PARTS
Parts may be ordered from your local CRAFCO distributor or directly from CRAFCO, Inc. if
a distributor is not available in your area. When ordering parts, give the following
information:
1. Part Number.
2. Machine Model.
3. Serial Number.
Write, telephone, or fax:
CRAFCO, INCORPORATED
25527 SOUTH ARIZONA AVENUE
CHANDLER, AZ. 85248
Phone: 480-655-8333
Fax: 480-655-1712
Toll Free: 1-800-528-8242
ELECTRIC HOSE CARE AND CAUTIONS
Twisting and kinking of the electric hose (used on LF, BAX, SS60, and SS125 Melter) is the
number one cause of hose failure.
When this happens, the electric heating wires are shorted out to the metal hose cover and
the hose stops heating.
This type of failure is not covered under the Crafco warranty .
To help prevent twisting and kinking and the resulting hose damage, the operator should:
a. Not move or use hose unless it has been turned on a least 35 minutes and
set at a minimum temperature of 300
°
F.
b. Make sure hose swivel between hose and wand moves freely.
c. Limit the hose bending to a radius of 10 inches.
d. Avoid bending the hose over sharp edges such as the edge of the frame or
tank.
e. Avoid twisting.
f. Do not exceed 400
°
F. on the hose controller or material temperature.