ergoline ergoselect 4, Руководство оператора

Страница: 65 / 96

9 Control Terminal T
ergoselect 4 / 5 63
9.2.4 Training with Chip Card
As an alternative to the training protocols saved in the
ergometer, it is possible to load training protocols from a
chip card.
The PC software “ergoline opticare basic” is used to write
the training protocols to the chip card.
Upon completion of the training session, the ergometer
saves the entire session (incl. load and heart rate wave-
forms) to the chip card – the data can be reviewed and
analyzed at the PC later on.
You can choose between three different chip card modes:
1. Chipcard possible
2. Chipcard only
3. Only CPC + Memory
The preferred mode can be set in the Service menu.
Figure 9 – 49: ergoline training chip card
"Chipcard possible" Mode
The Manual and Countdown operating modes are available
with "Chipcard possible".
These operating modes are not available with "Chipcard only".
Session Start with Chip Card Training Protocols
Insert the training card with the stored protocol into the
chip card reader (on the right side of the control terminal)
– the golden chip on the training card faces down.
Select the “Training” mode and confirm with
Start
.
Figure 9 – 50: Chip card reader