EG_GenPro2xe_1003_UG_005_UK
Page 33 / 63
Descriptions and non-contractual illustrations in this document are given as an indication only.
ERCO&GENER reserves the right to make any modifications.
Dct_427_00
6.2 "ERROR" message
The modem returns a message "
ERROR
" (in response to an AT command) in the following cases:
▪
The COM port is not directed to the modem GenPro 2xe but to another modem. Enter
ATI1
,
and
the response must be
Enabler_III
.... Any other response indicates a dialog with another modem.
In this case, check the COM port used in the Hyperterminal.
▪
The syntax of the AT command is incorrect : then check it (refer to document
"EG_EGM_CL_xxx_yy" ERCO & GENER.
▪
The syntax of the AT command is correct, but transmitted with wrong parameters:
- Enter the command
AT+CMEE=1
to obtain an error message with its error code instead of a
simple “ERROR” message,
- Enter again the AT command which previously caused the "ERROR" message in order to obtain
the error code.
In case of an error code, the response of the modem may be:
+CME ERROR : < error code >
For more information about the error codes returned by the command
AT+CMEE
, see the document
"EG_EGM_CL_xxx_yy" of ERCO & GENER.
It is strongly recommended to systematically allow the modem to return the error codes (enter
the command
AT+CMEE=1
).
