1. Remove the spray hose (10) from paint outlet (4) if it has not already removed.
2. Turn the airless paint sprayer upside down and loosen the clamps (6a/7a) from
both tubes (6/7), then disconnect tubes (6/7) from the pump of airless paint sprayer
(step 1).
3. Add one ounce of lubricant (type:
xxxxx
) into each tube inlet (step 2).
4. Turn Prime/Spray lever to the spray mode (step 3).
5. Hold a rag over the paint outlet (4) (Step 4).
6. Switch the product on for 5 seconds (Step 5), then turn the power OFF.
7. Turn Prime/Spray lever (3) to the prime mode (step 6) to release the pressure, and
lubricant is now stored in the pump of airless sprayer.
8. Wipe the airless paint sprayer with a clean cloth.
9. Arrange and store the disassembled prime tube (6), suction tube (7), spray hose
(10) and spray gun (14) properly in a suitable compartment.
10. Coil the spray hose (10) to prevent damage.
Maintenance
Before and after each use, check the product and accessories (or attachments) for
wear and damage. If required, exchange them for new ones as described in this
instruction manual. Observe the technical requirements.
01
Power cord
If the power cord is damaged, it must be replaced by the manufacturer, its service
agent in order to avoid a safety hazard.
WARNING!
Do not use the product with a defective or a loose power
cord!
02
UK PLUG (ONLY FOR UK MARKET)
If you need to replace the fitted plug, then follow the instructions below.
IMPORTANT: The wires in the mains lead are coloured in accordance with the following
code:
Blue – Neutral
Brown – Live
As the colours of the wire in the mains lead of this product may not correspond with
the coloured marking identifying the terminals in your plug, proceed as follows. The
wire, which is coloured blue, must be connected to the terminal, which is marked with
N or coloured black. The wire, which is coloured brown, must be connected to the
terminal, which is marked L or coloured red.
MNL_Erbauer_GB_EAPS600_600W Airless Paint Sprayer_V1_201029.indd 41
10/29/20 3:31 PM
42
