Suction tube / Prime tube connection
1. Align and insert the prime tube (6) and the suction tube (7) separately to the
corresponding attachment ports (Fig. B, step 1). Ensure that the tubes (6 / 7) are
pushed fully on to the attachment ports.
2. Secure the prime tube (6) and the suction tube (7) by squeezing the tabs on the
tube clamps (6a / 7a) and securing them over the attachment ports. (Fig. B, step
2).
3. Pull down on the prime tube (6) and the suction tube (7) to ensure that they are
securely connected.
Spray hose connection
WARNING!
Danger of injury by injection! Any damage to the high
pressure hose in the form of kinks, splits or general wear can result in
leakages. Leakages will eject material at high pressure and can cause
injury by injection into the skin.
Always obey the following rules:
• Check hose thoroughly before use for damage, wear and splits.
• Never use a damaged hose. Replace immediately.
• Do not attempt to repair a damaged hose yourself.
• Do not fold the hose or allow it to bend at angles less than a radius of
20cm.
• Protect hose from sharp edges.
• Do not use the hose to pull the sprayer.
• Do not allow the hose to twist.
• A coiled hose can present a trip hazard. Always lay it out safely.
1. Remove the sealing caps at two ends of spray hose (10). Retain the sealing caps
to re-fit to the hose after use. This will help to prevent the ingress of foreign objects
and dirt into the hose when not in use.
2. Connect the spray hose (10) to paint outlet (4) by thread and tighten with two
spanners (17#&19#) (26) (Fig. C). Ensure that spanner at the machine fitting is
held steady and use the other spanner to tighten the hose attachment. This will
prevent damage to the fitting.
3. Connect the other end of the spray hose (10) to spray gun (14) by thread and
tighten with two spanners (17#&19#) (26) (Fig. D).
Work area
1. Cover a wide area surrounding the spraying area thoroughly and keep the spraying
surface clean, dry and free of grease.
2. Use a piece of cardboard as a shield to catch overspray at the edges of the work to
protect the other surfaces.
MNL_Erbauer_GB_EAPS600_600W Airless Paint Sprayer_V1_201029.indd 28
10/29/20 3:31 PM
29
