3. Roughen smooth surfaces to improve paint adhesion and then remove the sanding
dust before painting.
Paint
1. Strain the paint through filter or a paint strainer.
2. Thoroughly mix the paint in accordance with the paint manufacturer's instructions.
The correct viscosity of the paint will greatly influence the paint results.
3. Paints and other coating materials should be thinned in accordance with the
guidance below.
Thinning recommendation
Sprayed material
Glazes
undiluted
Wood preservatives containing solvents or based on water,
mordants,oils, disinfection agents,plant protective agents
undiluted
Paints containing solvents and watersoluble paints, primers,
vehicle coating patints, thick-film glazes
dilute by 5-10%
Interior wall paint (dispersions and latex pating)
dilute by 0-10%
4. The values in the table are for reference only. The amount of thinning required
can only be determined by testing it. When diluting, do not exceed the amount of
thinner stipulated by the manufacturer of the material.
03
Connection to power supply
NOTE:
This tool is recommended for the use with a residual current
device with a rated residual current of 30mA or less.
1. Make sure that the On/Off switch (23) is pressed down at “O” position.
2. Connect the power cord plug (2) with a suitable socket.
WARNING!
Check the voltage! The voltage must comply with the
information on the rating label!
3. Your product is now ready to be used.
MNL_Erbauer_GB_EAPS600_600W Airless Paint Sprayer_V1_201029.indd 29
10/29/20 3:31 PM
30
