Copying Photos to a USB Drive
67
3. Connect a USB cable from your storage drive to the
EXT. I/F
port on the
front of the Stylus Photo RX700. (If you’re using a thumb drive, plug it in
directly.)
4. Press the
Setup
button.
5. Press the
d
button to choose
Backup Memory Card
, then press
OK
.
6. Press
OK
again to start the backup procedure. You may have to follow
additional instructions on the RX700 screen. All the photos on your card are
copied to your connected storage device. Depending on how many photos
there are, this may take several minutes.
7. When you’re done copying photos, make sure the memory card light is not
flashing and then remove the card.
Note:
When backing up photos to a CD-R/RW, the Stylus Photo RX700 creates a folder
for each backup session. You can store multiple backup sessions on a CD-R/RW.
Caution:
Once the backup starts, do not disconnect the cable or interrupt the process, or
you may lose data. If you need to stop the backup, press the
y
Stop
button.
Printing Your Stored Photos
Once you have copied photos to your storage drive, you can print them by
following these steps.
Note:
You can view and print photos this way only if they have been backed up to your USB
device as described in the previous section.
EXT/IF port
Содержание Stylus Photo RX700 Series
Страница 1: ...RX700 ALL IN ONE PHOTO CENTER ALL IN ONE PHOTO CENTER Basics ...
Страница 6: ...6 Contents ...
Страница 60: ...60 Printing on CDs and DVDs ...
Страница 92: ...92 Notices ...