Epson Stylus C87, Руководство по обслуживанию

Страница: 71 / 109

EPSON Stylus C87/C88/D88 Revision A
DISASSEMBLY/ASSEMBLY Dissasembly Procedures 71
9) Use a flathead screwdriver or a similar tool to release the two tabs of the CR
Unit.
Figure 4-67. Removing CR Unit
10) Slide the IC Holder toward you, and remove the CR Unit and the CR Timing
Belt from the Main Unit.
11) Remove the Timing Belt from the CR Unit. (See 4.3.3.5 Removing CR
Timing Belt Step 6)
„ When installing the CR Unit to the Main Unit Frame, engage
them as shown in
Figure 4-67 .
„ The Shield Plate FFC should be attached to the location shown
in
Figure 4-66 with double-sided tape.
Tab Tab
A D J U S T M E N T
R E Q U I R E D
„ After replacing or removing the CR Timing Belt, make sure to
perform the following adjustment.
•
CR Timing Belt Tension adjustment
„ After replacing or removing the CR Unit, make sure to perform
the following adjustments.
1. Head ID Input
2. Top Margin Adjustment
3. PF Adjustment
4. Bi-D Adjustment
5. Head Angular Adjustment
6. First Dot Adjustment
7. PW Sensor adjustment
8. Offset input for CR Motor Calorific Limitation
„ After replacing or removing the IC Holder/Printhead Assy.,
lubricate it as specified. See
Chapter 6 “Lubrication” (p.95) for
details.