Epson RIP Station 5100, Руководство администратора, Страница: 38 / 140

3
3-4 Performing Setup from the Control Panel
T
O ACCESS
S
ETUP WHEN THE
RIP S
TATION IS AT
I
DLE
:
1. Make sure the information screen on the Control Panel reads Idle.
If Printing or RIPping appears, the RIP Station is processing, and you must wait
until the system finishes and reaches the Idle state.
2. Press the Menu button on the Control Panel to go to the Functions menu.
3. Press the line selection button next to Reboot Server.
Use the up and down button to select Yes, and choose OK. After automatic
start-up diagnostics, the RIP Station displays the setup message.
4. At the setup message, press any key.
5. Choose Run Setup to access all Setup menus.
The Start System command bypasses Setup and boots the RIP Station to Idle.
The Install Software, Format Disk, Upgrade Flash, and Flash Info commands are
for service technicians.
If an Administrator password has been set on the RIP Station, you are prompted
to enter it before you can perform Setup (see page 3-41).
6. Press the line selection button to choose a Setup menu or command.
Press the down button to view the remaining screens of the main Setup menu.
7. Choose setups in the same order as they appear in the menu: Server Setup, Network
Setup, Printer Setup, PS Setup, Color Setup, and then Job Log Setup.
The sequence is important for first-time Setup. Later, just go directly to the menu
you want to change. However, if you make changes in Network Setup, you may
need to change some settings in Printer Setup as well.
8. Set an Administrator password to protect your Setup from unauthorized alteration.
Print Pages
Reboot Server
Functions
For software
update or setup,
press any key.
Run Setup
Start System
Install Software
Format Disk
Start Up
Upgrade Flash
Flash Info
Start Up
Exit Setup
Server Setup
Network Setup
Printer Setup
Setup
PS Setup
Color Setup
Job Log Setup
Change Password
Setup
Clear Server
Setup