Epson RIP Station 5100, Руководство администратора, Страница: 28 / 140

1
1-14 Connecting to the Network
T
O USE THICKNET CABLE
:
1. With the RIP Station turned off, connect the thicknet cable to the AUI connector on
the back of the RIP Station. Slide the latch to lock the connector.
2. Configure network servers for printing, and proceed to Setup.
T
O USE
U
NSHIELDED
T
WISTED
P
AIR CABLE FOR
100B
ASE
T
OR
10B
ASE
T:
1. With the RIP Station turned off, connect the RJ-45 cable to the Ethernet RJ-45 socket
on the back of the RIP Station.
2. Configure network servers for printing, and proceed to Setup.
Parallel cable connection
In addition to receiving print jobs over Ethernet, the RIP Station can accept print jobs
from a Windows computer through its high-speed parallel port. This connection is
advantageous for portable computers and for workstations on dedicated networks
using protocols other than AppleTalk, TCP/IP, or IPX.
The parallel port connection can be active at the same time as the network ports.
N
OTE
:
The parallel port cannot be used to connect the RIP Station with Fiery utilities.
T
O USE PARALLEL CABLE
:
1. With the RIP Station and the Windows computer turned off, attach the parallel cable
to the parallel port of the RIP Station.
See the illustration on page 1-13 for the location of the parallel port.
2. Connect the other end of the cable to the parallel port on the Windows computer.
3. Turn on the computer and the RIP Station.
4. Proceed to Setup.
To print to the parallel port, you need to set up the parallel port connection. See
“Parallel Port Setup options” on page 3-13. For information on setting up printing, see
the Setup Guide; for printing to the parallel port, see the User Guide.