Epson DLQ-3000+, Руководство пользователя

Страница: 6 / 228

❑
Unplug the printer and refer servicing to qualified service
personnel under the following conditions:
If the power cord or plug is damaged; if liquid has entered the
printer; if the printer has been dropped or the cabinet damaged;
if the printer does not operate normally or exhibits a distinct change
in performance. Adjust only those controls that are covered by the
operating instructions.
❑
If you plan to use the printer in Germany, observe the following:
To provide adequate short-circuit protection and over-current
protection for this printer, the building installation must be
protected by a 16 Amp circuit breaker.
Bei Anschluß des Druckers an die Stromversorgung muß
sichergestellt werden, daß die Gebäudeinstallation mit einem
16 A-Überstromschalter abgesichert ist.
Print Head Caution Symbol
The symbol on the print head indicates that this part may
be hot. Never touch the print head just after the printer
has been used. Let the print head cool for a few minutes
before touching it.
E
NERGY
S
TAR Compliance
As an
E
NERGY
S
TAR Partner, EPSON has determined
that this product meets the
E
NERGY
S
TAR guidelines
for energy efficiency.
The International
E
NERGY
S
TAR Office Equipment program is a
voluntary partnership with the computer and office equipment industry
to promote the introduction of energy-efficient personal computers,
monitors, printers, fax machines, and copiers in an effort to reduce air
pollution caused by power generation.
K
L
Maple Rev.D
A5 size Front
06/13/97 pass 0
iv