43
9 Stopping the Outboard
Usually, it’s recommended to stop the outboard as the following procedures.
1. Return the throttle to zero position.
2. Wait until the outboard stops, then detach the kill switch from the Remote
Controller/Tiller.
3. Press and hold the “
”button until the Remote Control/Tiller is
powered off.
4. Turn off the main switch. If the outboard is connected to a NAVY battery,
please also press the battery power button to power off.
5. Tilt the outboard above water surface or detach it from boat.
If the outboard motor will not be used soon, it’s recommended to keep
the outboard out of water, otherwise erosion may occur. In addition, it is
recommended to apply protective coating.
The outboard will stop if one of the situations occurs.
1) The throttle is in zero position.
2) The kill switch is not in the correct position of Remote Control.
3) The main switch is off.
4) The communication between Remote Control/Tiller and
outboard breaks.
5) The connection between battery and outboard breaks.
6) Failure exists in the control system (e.g. motor is blocked or the low
battery voltage level is detected).
Содержание NAVY 6.0 Series
Страница 1: ...NAVY 3 0 USER MANUAL November 2017 Version 1 1 Copyright 2014 2018 ePropulsion All Rights Reserved ...
Страница 2: ......
Страница 55: ......