36
Code
Cause
Solution
E11
The temperature of
motor is too high.
Stop operating the outboard and wait
until the temperature falls within the
normal operating temperature range.
E12
The temperature of
circuit board is too high.
Stop operating the outboard and wait
until the temperature falls within the
normal operating temperature range.
E14
Failure was found in
the motor temperature
sensors.
Try to turn off the main switch and wait
for 10 seconds then turn on the switch
again.
E15
Failure was found
in the circuit board
temperature sensors.
Try to turn off the main switch and wait
for 10 seconds then turn on the switch
again.
E16
Calibration Abnormality
of Current Sensor
Please contact the dealer for help.
E22
MCU Communication
Abnormality
Please restart to see if the error
disappears, if not, please contact your
dear for help.
E25
The remote is not
paired to the outboard
Pair the remote to the outboard.
E30
Throttle position
sensor failure, should
recalibrate the throttle
position sensor.
Please refer to section
5.3.3
Recalibration
to recalibrate the throttle
position sensor.
E40
System running failure
Please restart the Remote Control/
Tiller and the outboard.
E55
NAVY Battery is
running out of power
Charge NAVY Battery
E56
Communication
Error between NAVY
outboard and NAVY
battery
Check if the communication cable
between NAVY outboard and NAVY
battery is well connected, if yes, please
restart the system.
Содержание NAVY 6.0 Series
Страница 1: ...NAVY 3 0 USER MANUAL November 2017 Version 1 1 Copyright 2014 2018 ePropulsion All Rights Reserved ...
Страница 2: ......
Страница 55: ......