35
EN
The control unit is equipped with a “Switch-off”
rocker switch.
You will find this switch on the top side of the
housing by Econ series control units and on the
left side of the main relay box by control units
of Emotec, EmoStyle and EmoTouch series.
This switch allows to switch the control unit to
the standby mode (notice the heating will not
start), to switch the control unit completely off
(disconnect from power) or to switch the con-
trol unit off but to leave the light switched on.
Notice: if you leave the Econ control units
switched off for more than 24 h the time set-
ting will be lost. Other settings will be saved.
You will have to repeat setup and re-confirm
the settings.
!
Attention!
Parts of the printed cir-
cuit board will still remain energized in the
switched off condition! risk of electric shock!
Device switched on.
Position I.
Device switched off
(completely);
Position 0.
Light enabled;
Device switched off.
Position II.
The device „Switch-off“ switch
Press the switch on the lower side of the rocker
to the first latch (
switch setting 0
). The switch
will be in the middle position. The unit is now
completely switched off (disconnected).
To turn the light on in the cabin while the unit is
still disconnected push the left side of the rock-
er to the second latch (
switch setting II
).
To make the unit ready for operation, switch
back to the initial position (
switch setting I
).
The unit will return to stand-by mode.
Device switched on.
(default Position I)
Switch-off rocker switch by Econ
models
Switch-off rocker switch by Emotec,
EmoStyle, EmoTouch models
