28
Call 1300 369 273
www.enware.com.au
The eSQX™ Mixers come standard with either:
To change the sensor program, follow the programming sequence below in conjunction with the sensor
programs nominated in the following pages.
CHANGING THE SENSOR PROGRAM
AUTO SENSE
An Auto Sense activation which operates while the
user’s hands are in the sensor range.
The Auto Sense activation sensor comes with a
range of sensitivity functions that can be adjusted
in situations where the sensor is subject to
interference issues once installed.
ON DEMAND SENSOR
An On Demand Sensor activation where the user
places their hand in front of the sensor to turn it
on and off.
The On Demand Sensor activation sensor have a
range of automatic timed functions to suit different
hand wash applications and procedures.
STEP 1
Disconnect power to sensor.
STEP 2
Reconnect power and wait 5 seconds. The red LED light in
the sensor lens will turn on for 3 seconds, and then turn off by
itself.
STEP 3
Now press and hold the blue button located on the back of the
sensor - the red LED will turn on. Keep holding for 3 seconds until
the LED turns off. Release the button and you are now in program
mode.
STEP 4
Within 5 seconds, choose your program by pressing the button
the same number of times that corresponds with the program
number in the program chart. Eg. If you want program 2, press
the button twice. Each press will make the red LED light blink.
Refer to program charts.
STEP 5
Once the program is chosen, wait for 5 seconds. The LED will
blink back to confirm the program number it is set to.
The sensor is now set.
WAIT UNTIL RED LIGHT
TURNS OFF
WAIT UNTIL RED LIGHT
TURNS OFF
MAXIMUM 5 SECS