Enviro M55-FPIs640, Руководство пользователя

Страница: 11 / 40

Operating Instructions
a
djustabLe
a
ugeR
c
oveR
s
et
-
uP
:
The auger cover is located within the hopper.
This adjustment allows for greater control of the feed rate than offered by the feed trim positions on the
control panel. Due to varying density by volume in fuels it may be necessary to adjust this cover either up or
down to control the maximum output of 55,000 BTU. Lowering the cover position will decrease output and
raising it will increase output.
CAUTION
Increasing output too much can cause the high limit sensor to trip (flashing #4).
If this occurs lower the position of the cover and manually reset the sensor before
continuing to operate the unit.
11
How can I reduce the visible emissions?
If all of these steps are followed, there should be no visible emissions.