f
iRebox
L
ineR
i
nstaLLation
:
NOTE: The firebox liners are fragile and should be handled gently.
The following instructions can be used for all firebox liner options. For simplicity, only the
brick liner is shown.
1. Ensure the E20 is turned off and allow the unit
to cool.
2. Remove the glass door as shown in the
m
aIntenance
anD
s
erVIce
- g
lass
D
oor
r
emoVal
.
Warning: Do not touch or attempt to remove the glass
if the fireplace is not completely cool.
Never operate the fireplace with the glass
removed.
3. Remove the log set and all ember material (if installed).
4. There is a ledge at the back of the firebox (see Figure
54). Place the back brick panel on the ledge and
ensure the panel is flush at the bottom and top (refer to Figure 55). Do not push at the center of the
panel.
5. Slide the front of the left brick panel into the left lip at the front of the firebox. Ensure the panel is flush
to the side of the firebox and the back brick panel while still being hooked behind the front lip (refer
to Figure 56). Take care to not bump the brick panel on the burner.
6. Repeat step 6 for right brick panel.
7. Install the log set and ember material (refer to
s
econDary
I
nstallatIon
- l
og
s
et
anD
e
mber
I
nstallatIon
)
and the glass door.
Figure 55: Back Brick Panel in Place.
Figure 54: Back Brick Panel Ledge.
Figure 56: Side Brick Panels in Place.
Secondary Installation
30
LEDGE
